User manual

LOR800W & LOR160xW g3
35
click OK in the warning box for changing all unit
IDs, there should only be one unit attached.
2. Use the New Unit ID drop down menu to select
“01” or whatever Unit ID you want to assign to
the attached controller.
3. Click the Change Unit ID button to set your
lighting controller unit ID. You will see a Unit ID
Changed box – click OK.
The DMX address is set to (((Unit ID) – 1) * 16) + 1.
Creating A Sequence
This section assumes that you have used previous
sections to configure your controller and attach it to
your PC. If you haven’t done this, see the Assigning
a Unit ID and Testing with the Hardware Utility
sections.
The following screen shot is for later reference, it
shows the Sequence Editor with the completed test
sequence and labels for the functions used.
Figure 2
LOR800W & LOR160xW g3
36
First start the Showtime software control panel if it
is not already running by clicking start ► All
Programs ► Light-O-Rama ► Light-O-Rama
Control Panel. There will be a light bulb with a red
halo at the bottom of the screen on the right or it will
be in the pop-up menu accessible by clicking the
up-arrow.
Stop the Hardware Utility if it is running because
only one LOR program may use the
communications port at a time. Right-click the light
bulb and select Sequence Editor from the menu
and you will see this window:
Click New Animation Sequence light bulb and click
OK, you will see the following window: