User manual

LOR800W & LOR160xW g3

Connected to LOR Network:

The display steadily shows “L-01,” meaning the

controller is set to LOR Unit ID 01.

Connected to DMX Universe:

The display steadily shows “d001” meaning the

controller is set to DMX address 001.

Loading Firmware:

Resetting:

“0000” is displayed for a couple of seconds while

the controller is resetting. See the Resetting the

Controller section for more information.

Running a Standalone Sequence:

LOR800W & LOR160xW g3

Assigning a DMX Address

To set the DMX Address, press the Select/Set

button until the status display flashes “dnnn” where

nnn is the current DMX address. Use the ▼and

▲buttons to select the DMX address you want and

then press the Select/Set button to save the DMX

address. You can hold the ▼or ▲button down to

scroll through addresses.

You can also set the DMX Address with the

Hardware Utility. In this case you set the Unit ID

which sets the DMX address to (((Unit ID) – 1) * 16)

+ 1. See the Setting the Unit ID with Software

section.

A cable that plugs into one of the controller’s RJ45

jacks and terminates with in a male XLR-3 plug is

available here: www.lightorama.com ►LOR Store

► Accessories ► RJ-45 to XLR 3-Pin Male

Assigning a Unit ID

To set the Unit ID, press the Select/Set button until

the status display flashes “L-nn” where nn is the

current Unit ID. Use the ▼and ▲buttons to select

the Unit ID you want and then press the Select/Set

button to save the Unit ID. You can hold the ▼or

▲button down to scroll through IDs.

You can also set the Unit ID with the Hardware

Utility. This will also set the DMX address to (((Unit

ID) – 1) * 16) + 1. See the Setting the Unit ID with

Software section.

Each LOR light controller used in a network must

have a unique ID assigned. [If two controllers are

given the same unit ID, then they will both perform

the same effects.] Every channel that you control in