User manual

LOR800W & LOR160xW g3
21
This initial configuration shows all channels
configured for the Standard curve, also shown is
one custom curve file loaded into the controller and
two custom curve files located on the PC disk.
The LOR800Wg3 is an 8 channel controller so
channels 9 through 32 are grayed out. The
LOR160xWg3 are 16 channel controllers so
channels 17 through 32 are grayed out.
To transfer a new curve from the PC to the
controller or update an existing curve on the
controller from the PC, click the appropriate “Load
nn” button. The curve file on disk will be transferred
to the controller. The vertical progress bar to the
right of the “Load nn” buttons will indicate percent
transferred to controller.
The Read Unit’s Config button will ask the controller
for its channel to curve file mapping and show
which custom curves are loaded into the controller.
LOR800W & LOR160xW g3
22
Setting Multiple Channels in a Group
You can change the curve association for multiple
channels in channel group 1-8 or channel group 9-
16 using the “All” row above that channel group. If
you check the “All” box, then all channels in that 8
channel group will be affected. If you only want to
change some of the channels in the group, check
their individual check boxes. Then use the drop
down menu in the “All” row to select the curve for
the checked channels and click the Set Checked
button. Those channels will be changed to the
curve selected. Finally, click the Update Unit’s
Config button to send the new curve configuration
to the controller.
Setting Individual Channels
Do not check the “All” box, but do check the boxes
to the left of the channels for which you want to
change curves. Then use the drop down menu next
to the checked box to select the curve you want for
that channel. Finally, click the Update Unit’s Config
button to send the new curve configuration to the
controller.
Note: If you configure a channel for a curve that
does not exist in the controller, the Standard curve
will be used.
Example
In the following example, channels 3 and 4 are
being set to custom curve 01 and channels 15 and
16 are being set as On/Off only channels. The
check boxes for channels 3, 4, 15 and 16 are
checked and the drop down menus have been used
to select the desired curves: