Manualshelf

User guide

ManualsBrandsAnimas ManualsMedical Equipment2020
31323334353637383940
Page 39
7
Note: The next available empty basal segment will appear automatically as you program the
previous segment. If the next empty basal segment does not appear, you have programmed all
12 possible segments.
8. Change next Start time field as desired, press the OK button to exit Edit mode. Segments
can start on the hour or half hour.
Note: The 24 hour Total changes automatically as you change U/hr settings.
9. Continue until basal segments have been set as recommended by your healthcare team.
10. When finished, scroll to Save/Review and press OK. If you have
edited the active program, it is now resumed automatically. The Basal
Options screen is displayed.
Note: If your screen display has timed out (gone to sleep) before you
have selected Save/Review while editing, a Warning screen will remind
you the basal edit has not been saved. See Chapter 14, Safety System
and Alarms.
11. Review is highlighted. Press OK to review your entries for
accuracy. Your basal segment settings are shown (5 on first screen,
5 on second screen and 2 on last screen). If you have more than
5 segments programmed, scroll to Next to see second and third
screens as desired.
12. Options is highlighted. Press OK. The Basal Options screen
is displayed.
If you’ve edited and saved/reviewed the active program, a.
it is resumed automatically. You can also select Go and the
Home screen is displayed, which shows the current rate of
delivery for the program that is active.
If you’ve edited an inactive program and wish to activate b.
it, select Go from the Basal Options screen. When you select
Go, the Home screen is displayed, which shows the current
rate of delivery for the program that is active.
Adding/Changing Segments in an Existing Basal Program
1. From Basal Menu, select desired program.
2. Edit is highlighted. Press OK.
3. Scroll up to highlight the field you wish to change or to next available blank line to add
a segment. Press OK to activate Edit mode. (The cursor will flash to indicate Edit mode.)
4. Use Up/Down buttons to set Start times and U/hr amounts.