User`s manual

User’s Manual of TC Series Cutting Plotter
3 Lift up / adhere
When cutting over…
1. Cut off the paper with scissors or a knife.
2. Get rid of the useless part with tweezers (you can easily do this if you add a
side frame around the pattern when cutting).
3. Adhere a special “over-pasted film” on the cut pattern and stroke it with a
scraper.
4. Lift up the “over-pasted film” and paste it on the any place you want, then
tear the film off.
4 After work is over…
1. Lift the pinch-roller handle.
2. Remove the paper.
3. Remove the cutter holder or plotter holder, then wipe it clean with a soft-cloth
and keep it properly.
4. Turn off the power, and pull the power cord out if not using during a long time.
5. Cover the machine with a cloth or a cover.
１８