User Guide

7 Under Counter Mounng Desktop Mounng 8
Mounting your Mic Tally Gadget under a counter.
Your Mic Tally Gadget can be mounted under a counter, desk, or table using the
optional Under Counter Mount Kit.
This kit includes two brackets, four No. 6 wood screws, and four cup washers
suitable for mounting to a plywood surface. Different hardware (not supplied) may
be needed if the mounting surface is a different material.
Remove the four rubber feet (”A”) from the bottom of the Gadget using a #1
Phillips screwdriver, being careful to save the screws.
Line up the brackets (“C”) so that their
mounting holes line up with holes
exposed after removing the rubber feet.
Orient the brackets as shown in the
diagram to the right so that the deeper
flat side supports the Gadget and the
“notched” side faces the under mount
surface.
Use the panhead screws (“B”) removed
from the rubber feet to secure the
brackets to the Gadget.
Use the four provided No. 6 screws (“D”)
and the four cup washers (“E”) as shown
in the diagram to the left to secure the
Gadget to the plywood underside of the
counter, desk, or table.
Drilling pilot holes is recommended to
reduce the risk of splitting the wood.
Using your Mic Tally Gadget on a desktop.
If you like the idea of using the Mic Tally Gadget on a desktop but prefer a more
permanent installation along with the convenience of having it angled up toward
the user, we’ve got you covered with the optional Desktop Bracket Kit.
This kit includes two brackets, four No. 6 wood screws, and four cup washers
suitable for mounting to a plywood surface. Different hardware (not supplied) may
be needed if the mounting surface is a different material.
Remove the four rubber feet (“A”) from the bottom of the Gadget using a #1
Phillips screwdriver, being careful to save the screws.
With the bottom of the Gadget facing
up and the front panel facing toward
you, line up bracket “C” with the holes
exposed after removing the feet on
the right side of the Gadget. Orient the
bracket as shown in the diagram to the
right so that the flat side is attached
to the Gadget, and the “notched”
side sticks up with the notch facing
outwards. Use the panhead screws
(“B”) removed from the rubber feet to
secure the brackets to the Gadget.
Use the four provided No. 6 screws (“E”) and cup
washers (“F”) as shown in the diagram above to
secure the Gadget to a plywood surface.
Drilling pilot holes is recommended to reduce the
risk of splitting the wood.
7 Under Counter Mounting
Desktop Mounting 8
7 Under Counter Mounting
Desktop Mounting 8
7 Under Counter Mounting
Desktop Mounting 8
e
e
7 Under Counter Mounting
Desktop Mounting 8
7 Under Counter Mounting
Desktop Mounting 8
m
7 Under Counter Mounting
Desktop Mounting 8