led port-a-cube CT-DLLED CT-DSLED INSTRUCTIONS
Introduction Congratulations on purchasing the Angler LED Port-a-Cube. The Angler LED Port-a-Cube is a foldable and portable lighting solution for product photography. It features bright LEDs adjusted for 5400K color temperature, and are built into the Port-a-Cube so there’s no extra assembly. The LEDs deliver clean, even, and shadowless lighting that is flicker free, ensuring consistent exposure for every shot.
Precautions Please read all instructions carefully before assembling and operating this product. Use this light with only the rated voltage on the power supply, as any misuse could risk damage or malfunction. Avoid using this light in any high-moisture environments, as this could also cause damage or malfunction. To prolong the life of the unit, turn the power off and unplug the light when it is not in use. Do not attempt to disassemble or repair this product.
Silver reflective lining A Background pocket LED strip E D B F Touch-fastener strips C Handle Top photo window 4 Mesh pocket Front photo window Closing panel
Backgrounds (gray, green, white, black) Power adapter with dimmer Diffuser Power cable 5
Assembling the LED Port-a-Cube Fold up panels A, B, and C. Make sure the touch-fastener strips are fully connected. B C A 1. 1 3. (Optional) Insert the blank end of the background into the background pocket on panel D, and match the touch-fastener pads with the touch-fastener strips on panel F. 2 Lift panels D and E to complete the enclosure. Make sure the touch-fastener strips are fully connected. D A 3 4. Rotate the Port-a-Cube so side B is on top. 4 6 E 2.
5. 6. (Optional) To attach the diffuser, pull the top open, and connect the diffuser to the touch-fastener strips on panels A and C so the diffuser covers the LED strip when assembled. B A D 5 C E Plug the LED Port-a-Cube into an AC power source, and adjust the desired brightness level with the dimmer.
Packing the LED Port-a-Cube 1. Unplug the power adapter from the power outlet and the LED strip’s power cable. 2. Disassemble the LED Port-aCube so each panel is lying flat, and insert the backgrounds into the background pocket. 2 3. Fold panel B onto panel F. Make sure the LED power cable is not sticking out. 3 4. Fold in panels A, C, and E.
5. Fold the Port-a-Cube together. 5 6. Fold the flap over matching the touch fastener strips. You can store the power adapter, cables, and diffuser in the outer mesh pocket.
Specifications CT-DSLED 17 in. LED count 120 Color temperature 5400 K Power consumption 50 W Input power 85–265 V, 50/60 Hz Output (voltages vary depending on the input) 25–40 V @ 1500 mA 30–55 V @ 900 mA 28–45 V @ 1200 mA Dimmer range 10% to 100% Dimensions 17" × 17" × 17" (43 × 43 × 43 cm) Weight 2.65 lb. (1.2 kg) CT-DLLED 27 in. 10 LED count 150 Color temperature 5400 K Power consumption 65 W Input power 85–265 VAC, 50/60 Hz Output (DC) +42 V / 1.5 A max.
One-Year Limited Warranty This Angler product is warranted to the original purchaser to be free from defects in materials and workmanship under normal consumer use for a period of one (1) year from the original purchase date or thirty (30) days after replacement, whichever occurs later.
ANGLER A Gradus Group Brand GG1
