User Manual

Power Supply

Plug the power cord into the back of the ﬂash unit. Before plugging the power cord

into the wall socket, make certain that the power switch is set to the OFF (O)

position. The Glamour Flash is designed to automatically ﬂash, if necessary, when

turned o. The resistive dump will continue to reduce any remaining energy while the

unit is o. This is a safety feature and cannot be disabled.

Note: The Glamour Flash unit is designed to work on 110-120V 50/60Hz AC current.

Power Switch

Turn the power switch to the ON (I) position. The ﬂash will sound a beep and the

LCD will show the current ﬂash power setting. We recommend charging the ﬂash unit

for one hour prior to its initial use and after an extended period of inactivity (more

than two weeks). If the unit is left unused for a few months, or the unit has been used

predominantly at low power settings, we recommend that the power be increased to

the maximum and the unit left switched on (with the modeling lamp OFF) for at least

30 minutes, to help preserve the life of the capacitors.