User Manual

A 6A fuse is mounted in the rear panel and protects the circuitry of the ﬂash unit.

Turn o the unit and disconnect the power supply before changing the fuse. Never

replace with a fuse of a dierent type or rating. A spare 6A fuse is ﬁtted within the

fuse holder. Use a small screwdriver to release the fuse cover (14). Remove the old

fuse (15) and place the new fuse in the slot. Then replace the fuse holder (16).

Changing the Fuse

Installing a New Flashtube

Make sure the power switch is o and the power cord is disconnected from the source.

Locate the two ﬂashtube pin sockets below the modeling lamp socket. Using white

cotton gloves or a clean cloth, push the pins of the ﬂashtube into the sockets using

ﬁrm, even pressure at the base of the ﬂashtube. With needle-nose pliers, fasten the

retention spring over the hook above the ﬂashtube. Re-insert the modeling lamp using

white cotton gloves or a clean cloth. Re-install the reﬂector.

15 16