User Manual

Discharging the Flash Unit
The charge in the flash unit must be
discharged before removing the flashtube.
Make sure the flash unit is on. Push the
TEST button on the rear panel of the flash.
The unit will flash, discharging the power.
Immediately turn o the power switch
on the rear panel. Unplug the power cord
from the power source. It is advisable to
wait at least 30 minutes before touching or
removing the flashtube.
Removing an Old Flashtube
First, remove the reflector. Then, using white
cotton gloves or a clean cloth, remove the
modeling lamp (11). You will need to remove
the retention spring wrapped around the top
of the flashtube. With needle-nose pliers,
unhook the retention spring loop (12). Using
white cotton gloves or a clean cloth, grip the
base of the flashtube on each side. Carefully
pull the flashtube from the flash unit (13).
Changing the Flashtube
11
12
13
14