User's Manual

6
ANGEL FLY
© 2004 WDP LTD.
VELOCITY ADJUSTMENT
DECREASING VELOCITY
The velocity adjusting screw is located on the lower portion of the front grip.
· To decrease the velocity, insert a 3.0mm A/F Allen key and rotate
CLOCKWISE.
· The new input pressure to the ANGEL may be observed from the micro
pressure indicator on the flash tank.
INCREASING VELOCITY
The velocity adjusting screw is located on the lower portion of the front grip.
· To increase the velocity, insert a 3.0mm A/F Allen key and rotate
ANTI-CLOCKWISE.
· The new input pressure to the ANGEL may be observed from the micro
pressure indicator on the flash tank.
IMPORTANT NOTE:
· When reducing velocity, allow four shots for the complete system to be at the
new regulated pressure.
TWIST LOCK COLLAR FEED
The Twist Lock Feed Collar is a dual feature that retains your loader securely to
the ANGEL.
TWIST LOCK COLLAR
· To secure your loader, first ensure the Twist Lock collar is backed off by
rotating it counter-clockwise.
· The Twist Lock Collar feature has been supplied with two sizes of ‘O’
rings 1 to ensure that the full range of loader neck sizes are covered. If
the loader is difficult to insert when 5 has been backed off, follow the
procedure to replace the ‘O’ rings:
· Unscrew
5 by rotating counter clockwise.
· Extract spacer
2.
· Extract ‘O’ rings
1 and replace with compatible size.
· Re-assemble in reverse order.
· Insert the loader into the feed neck and rotate the Twist Lock collar
clockwise to secure the loader.
VOLUMIZER ACCESSORIES
The ANGEL has been designed to accept volumizers that attach to the front
of the ANGEL. Attachment of volumizers will allow the working pressure of the
ANGEL to be reduced to suit specific performance requirements.
The volumizer supplied with your ANGEL will reduce the operating pressure to
aproximately 150 psi.
· Unscrew and remove the mini regulator.
· Remove the left end cap
1 using suitable metric 4.0mm A/F Allen key.
· Ensure the valve spring, support bobbin
2 and exhaust valve stem
remain in place.
· Replace the left hand cap with the volumizer - 3
IMPORTANT NOTES: For re-assembly of components
· Ensure the valve spring, support bobbin and exhaust valve stem remain in
place.
· Ensure the end cap is located correctly.
· THE ANGEL IS LIVE AND CAPABLE OF DISCHARGING
.
· Paintball industry standard eye/face/ear and head protection designed
specifically to stop paintballs and meeting ASTM standard F1776 (USA) or CE
standard (EU) must be worn by user and any person within range.
· Always measure your markers velocity before playing paintball, using a suitable
chronograph.
· Never shoot at velocities in excess of 300ft (91.44 meters) per second, or at
velocities greater than local or national laws allow.
 WARNING
ADHERE STRICTLY TO THESE
AND ALL OTHER SAFETY
INSTRUCTIONS AND GUIDELINES
· Ensure a barrel blocking device is fitted to the ANGEL.
· Ensure the hopper is removed from the ANGEL.
· Ensure that there are no paintballs in the ANGEL.
· Always remove the first stage regulator and relieve all residual gas pressure
from the ANGEL before disassembly.
· The ANGEL can hold a small residual charge of gas, typically 2 shots, with the
first stage regulator removed. Always discharge the marker in a safe direction to
relieve this residual gas pressure.
 WARNING
ADHERE STRICTLY TO THESE
AND ALL OTHER SAFETY
INSTRUCTIONS AND GUIDELINES
Velocity Adjustment – Twist Lock Feed Collar – Volumizer AccessoriesOPERATION
2
1
3
1
2
3