Specifications

lNSTALLATlON lNSTRUCTlONS (Continued)
CASTER LEVELING INSTRUC- CASTER LEVELING INSTRUC-
TIONS
(Continued) TIONS (Continued)
5 . Completely unscrew the bolts holding the
caster mounting plate that requires leveling
adjustment. Retain the locking nuts for later
reassembly.
6 . Reinsert each bolt through its flatwasher and
the fryer mounting bracket; next, place a
spacer of the required thickness on the bolt
before inserting the bolt through its mounting
hole on the caster mounting plate and screw-
ing a locking nut onto the bolt.
7 . Repeat step 6 for all remaining bolts.
FRYER RESTRAINING DEVICE INSTALLATION INSTRUCTIONS
1 . Install one restraining device connector into
the structure wall directly behind the fryer’s
desired location, as shown in Figure 2.
2 . Install one restraining device connector on the
rear panel of the fryer very close to the quick-
disconnect device on the end of the fryer’s gas
line.
3 . Attach one end of the restraining cable to the
wall connector. Attach the other end to the
fryer connector.
4 . Confirm that the fryer cannot move far enough
away from the wall to cause excessive move-
ment of the flexible gas line or its associated
connectors.
9
8 . Tighten all four locking nuts evenly and
securely against the caster mounting plate and
the fryer bottom mounting bracket.
9 . Return the fryer to its desired location and
check again for wobbling or rocking.
Repeat steps 3 through 8 until no wobbl-
ing or rocking occurs. When the fryer no
longer wobbles or rocks, perform step 10.
10. Next, perform the “Fryer Restraining
Device Installation Instructions.
”
!
WARNlNG
Fryers MUST have a movement-
limiting (restraining cable) device
installed to prevent tipping that
causes splashing or spilling of its
HOT contents.
NOTE: This movement-limitin
g
device is to be furnished an
d
installed by the fryer’s install-
ing contractor before the frye
r
is connected to the gas line at its
desi
r
e
d
l
oc
a
tio
n
.