Instruction manual

!How to wire !
Q) Remove 4pcs. of M5 bolt at motor terminal box and remove protection cover.
* Be careful not to lose removed M5 bolts and washer.
® Wiring diagram is shown inside protection cover.
Single1)hase specifications
You can change to a
100V or 200V connection by changing terminal plate (2pcs .) .
* It is wired to 200V when delivered to you.
If you want to change to a 1 OOV connection, remove M4 nut of electric source
terminal and change terminal plate as illustrated below.
Insert electric
source cord through cable1Jland on the right side of terminal bo x.
El ect ri c So ur ce
Terminal M4 Nu
Terminal Block
Three1)hase specifications
Terminal plate ( 2pC5 )
200V
Connec ti on
(When delivered to you)
Ground Terminal
MS Bolt
o o
100V Co nn ection
You can change to a 200V or 400V connecti on by changing terminal plate (3pcs.).
* It is wired to 200V when delivered to you.
If you want to change to a 400V connection, remove M4 nut of electric source
terminal and change terminal plate as illustrated below.
Insert electric
source cord through cable1Jland on the bottom side of terminal box.
Connect each phase L
1-t.2-t.3 to each electric source terminal respectively in
accordance with the below wiring diagram.
Ground Terminal
MS
Bolt
Electric Source
I
200V Co nn ection
(When de
li vered to you)
- 16 -
0 ;--- _____ 0
400V Co nn ection