Setup Guide

4
SETUP GUIDE
Plug in your On the Go
1 Remove and discard the red band.
2 Insert the charging cable in the plug and insert into
an electrical outlet not controlled by a light switch..
3 The LED light will turn solid red and the device
will announce, “Your device is now charging.”
4 When your device has adequate battery charge
and is connected to the cellular network, it will
announce, "Your device is now ready, If you need
to place an emergency call please press and
hold the HELP button now."
5 The first time you turn on your system it may
announce, “Hello, it is time to test your system to
make sure it is working properly. Please press and
hold the HELP button for one second now.”
Please make this test call when requested.
6 Leave your device on the charging cradle until
the LED light is green, indicating that your
device has completed charging.
On the Go:
Setting Up Your System
A complete
charge will take
approximately
2-3 hours.
*
Test your system monthly!
Charge your device daily!