User manual

12 Anedio D1 DAC
Trouble Shooting
Symptoms Remedy
No power
• Ensure the power cord is plugged in fully.
• Check the fuse. If blown, ensure that the
outputs are not shorted. Replace it only with
0.2A/250V 5x20mm Time-lag (slow-blo).
Using an incorrect fuse will void the warranty.
Power on but no
sound
• Ensure that the correct channel is selected.
• Ensure that the source component is turned
on.
• Ensure that the D1 DAC is not muted,
indicated by “0” on the volume display.
• Ensure that the power amplifier is turned on.
• Ensure that the interconnects and cables are
plugged in fully and seated properly.
• If the above steps do not solve the problem,
recycle power by turning off the D1 DAC,
waiting 10 seconds, and turning it back on.
No sound through
USB (Ch 1)
• In your media player, ensure that “USB Audio
DAC” is selected as the device for playback.
Hum
• Ensure that all components are connected to a
single power strip.
• If there is a cable TV or antenna connection,
ensure that the cable/antenna grounds are
galvanically isolated from the audio ground.
This may require inserting a ground isolator.
Diffused stereo
imaging
• Ensure that the loudspeaker phase is not
inverted.
If the problem persists, please contact Anedio via the Contact page
at www.anedio.com.
WARNING: Repairs are to be performed by qualified service
personnel only. To reduce the risk of electric shock, do not perform
any servicing other than that contained in the operating
instructions.