Data Sheet

Place the two 5/16”
Washers (am-1009)
onto the CIM shaft.
Place the 2x2x10mm
Machine Key (am-
1121) into the
keyway. Push the
14T gear (am-0034)
Use a 3/8” socket to
press the 8mm
Retaining Clip (am-
0033) onto the face
of the gear
The picture shows
where the 1/8”
Machine Key (am-
1043) will be
inserted, after the
pulley (not pictured)
is finally inserted.
Insert the ¼-20 x ½
BHCS (am-1039)
through the 1/4”
Washer (am-1027)
and into the end of
the output shaft. This
will keep the pulley
secure.
Step 13
Step 9
Place the plate and
bearings over the
housing’s plastic
locating studs. The
bearing flanges
should be inside the
gearbox.
show picture of step here
Step 12
show picture of step here
Step 8
Press in FR8ZZ
bearing (am-0030)
and FR6ZZ bearing
(am-0028)
1
am-1042
4
am-1027
1
am-1039
1
Parts Needed On This Page
am-1047
Take the screw and
nut pack from am-
3296 and fasten the
plate to the housing
with the 10-32 x 0.75”
SHCS (am-1047) and
10-32 Nylock nuts
(am-1042).
am-0028
am-1043
6/20/2016
REV
DATE:
1
SECTION
REV:
show picture of step here
Step 11
Tools Needed On This Page
Toughbox Micro
am-0030
1
QTY
4
1
am-3230_107
PAGE
2
of 2
1
PART REV: