Data Sheet

ManualsBrandsAndyMark ManualsGear MotorsToughbox Micro 5.95:1 CIM Motor Gearbox (Angled)

PART REV:

SECTION

REV:

am-3230_107

Toughbox Micro

REV

DATE:

6/20/2016

QTY

Step 3

Step 2

Step 1

Insert the small end

of the output shaft

into the remaining

R6ZZ Bearing.

Step 4

Insert the 16T 3/8"

hex gear (am-0747)

over the small hex

shaft (am-0152) with

the flat side down.

Step 5

Tap the ½” eClip

Ring (am-0206) into

the grooved slot of

the Toughbox output

shaft (am-0153).

Step 6

Place the 48 Tooth

½” Hex Gear (am-

0885) onto the output

shaft, the flat side

down. Use grease

packet (am-2768)

and apply grease to

all of the gear teeth.

Parts Needed On This Page

Tools Needed On This Page

am-0516

am-3157

am-0152

am-0149

am-0747

am-0206

Press the R6ZZ

bearings (am-0516)

into the two center

holes of the

Toughbox Micro

housing (am-3157)

Insert the Toughbox

small hex shaft (am-

0152) in the bottom

bearing.

am-0153

am-0885

am-2768

Insert the 50T 3/8"

Hex gear (am-0149)

onto the small hex

shaft with the flat side

up.

Step 7

PAGE

of 2

Summary of content (2 pages)

PAGE 1
PART REV: am-3230_107 Toughbox Micro QTY Parts Needed On This Page 2 am-0516 1 am-3157 1 am-0152 1 am-0149 1 am-0747 1 am-0206 1 am-0153 1 am-0885 1 am-2768 Step 1 Press the R6ZZ bearings (am-0516) into the two center holes of the Toughbox Micro housing (am-3157) SECTION REV: 1 REV DATE: 6/20/2016 1 Tools Needed On This Page Step 4 Insert the 16T 3/8" hex gear (am-0747) over the small hex shaft (am-0152) with the flat side down.
PAGE 2
PART REV: am-3230_107 Toughbox Micro QTY Parts Needed On This Page 1 am-0030 1 am-0028 4 am-1047 4 am-1042 1 am-1043 1 am-1039 1 am-1027 SECTION REV: 1 REV DATE: 6/20/2016 1 Tools Needed On This Page Step 11 Take the screw and nut pack from am3296 and fasten the plate to the housing with the 10-32 x 0.75” SHCS (am-1047) and 10-32 Nylock nuts (am-1042).