Operating Manual

Operating manual: Metris Vibe
Rev.: 03
ANDRITZ
Page 6 of 25
March 22, 2022
1 INTRODUCTION
This manual is describing the METRIS VIBE sensor supplied by ANDRITZ.
Condition Monitoring Systems (CMS) are described as systems that monitor the condition of
machines and systems to provide advanced detection or prediction of damage.
As consequences increased vibrations are indicating increased wear, damage to bearings,
rotating parts, the frame of the machine or the building. To identify characteristic frequencies
Fast Fourier transformation is used.
The Andritz METRIS VIBE sensor uses Bluetooth (BLE) communication to send information via
Industrial Gateways to a Cloud for further analyzing and storage.
The sensor is taking short samples of the actual vibration stream based on an adjustable interval.
The manual contains essential information on correct, safe, and fit-for-purpose operation of the
Metris Vibe sensor. Adherence to these instructions helps to avoid dangerous situations known
to date.
1.1 ABOUT THIS MANUAL
Target audience
The personnel assigned to work with the Metris Vibe sensor must read the manual before
commencing work. It is too late to do so while working on the equipment, which may have serious
technical and health consequences.
In particular, the following must be considered:
• the entire Safety section and
• the safety instructions provided in the individual sections of the manual.
1.2 WARRANTY AND LIABILITY
ANDRITZ excludes warranty and liability claims for defects or damage if these are due in
particular to one or several of the reasons mentioned below:
Non-compliance with safety information, recommendations, instructions, and/or other
information in the manual.