User's Manual

AE04B-A0279 Rev -- APPENDIXA: AMPLIFIER INSTALLATION
Document use is restricted to that described on cover
A-3
1. Location found
2. Install the amplifier to the wall using mounting kit
3. Material used from mounting kit for wall installation.
• Channel (Qty - 2ea)
• Clamp Nut (Qty - 4ea)
• 3/8”-16 X .75 Hex Head Bolt
• Flat Sealing Washer
4. Materials provided for wall mounting of unistrut.
• Anchors (EAHRS-00002) (Qty – 4ea)
• Screw, Pan Head, #10-32 X 1.50 (Qty – 4ea)
• Washer, #10 (Qty- 4ea)
5. Prepare Unistrut
a. Drill two holes (0.219 inches in diameter) in each mounting unistrut.
b. The holes should be located between the slots and spaced approximately 12
inches apart, centered in the unistrut.
c. Prepare Holes in wall.
d. Mark hole locations from modified mounting unistrut.
e. Unistruts should be spaced 11.60 inches apart (center to center)
f. For wallboard approximately 5/8 in. thick.
• Drill 3/8 in. diameter holes
• Depress wing tabs so that anchor will fit into hole
• Push in until flush with wallboard
g. Concrete Installation
• Drill 3/8 diameter hole approximately 1 in. deep
• Depress wing tabs so that anchor will fit into hole
• Push in until flush with outside surface of concrete
h. Mount channels to the Wall
• Line mounting unistruts up with the holes drilled in the wall
• Use #10 hardware to install
i. Install amplifier to Channels
• Install the clamp nuts from the mounting kit into the mounting unistrut.
• Use the 3/8 hardware supplied with the mounting kit to install the amplifier to
the mounting unistrut.