Technical data

Installation Procedures
47
Step 13
Start snug tighten all hardware following steps below:
1. All shoulder bolts on all joint plates
2. All inside torsion panels 5/16 bolts on all joint plates
3. All exterior 5/16 bolts on all joint plates
4. Tighten 8 rib bolts (4 at each side) high at a time going around the reflector
5. Tighten all mount ring hardware
1
1
2
Inside Bolts
4
3
3
STEP STEP STEP
STEP
STEP
STEP
Figure 59
Figure 60