Technical data

Installation Procedures
45
Step 8
Step 9
Step 10
Place the correct match-marked rib (7544097) on the seam and insert and hand tighten all
rib hardware (special shoulder bolt). Insert capscrews from concave side of reflector panels.
Install remaining panels and ribs per the previous instructions Note: Leave one panel and rib
unassembled until ring is in place and assembled.
Before the last panel is in place, carefully unscrew mount ring (7544098) from the crate - lay
center mount ring (7544098) on top of antenna in correct position. Ring is stamped to the
ribs marking. You can also slide cone (7545141) under the reflector for future installation or
leave it till later feed installation.
Figure 55
Figure 56
Figure 57-A