Technical data

Installation Procedures
43
Step 4
Step 5
Place the center of the first panel (7541278) on the 34 inch standoff and outer rim of panel
on supporting blocks with concave side down. Place the center of the second panel on the
center brace insure that the match-markings are correct. (Ex: A to A, B to B…… ) as shown in
Figures below.
Insert and hand tighten special hardware shoulder bolts to the first joint plate connection.
2X9858-11 Shoulder Bolts
2X9999-59 Nuts
2X9997-56 Flat Washers
Figure 51
Figure 52