Technical data

The front and rear brackets should be aligned as shown in Figure 28. Figure 28 illustrates a
final azimuth strut assembly mounted to the ground mount assembly.
The next step is to install the elevation strut assembly. Begin by bolting the elevation
strut tube assembly (P/N 205872) to the ground mount assembly as shown in Figure 29.
Bolt the elevation bracket-support plates (P/N 205873) to the elevation strut tube
assembly using 5/8 inch hardware (hex bolt, flatwasher and nut) as shown in Figure 30.
The elevation strut tube assembly should now be bolted to the elevation strut bracket.
Installation Procedures
Step 10
Step 11
Step 12
30
Figure 28
Figure 29 (Top View) Figure 30 (Top View)