Technical data

Attach the ground mount assembly to the eight corresponding anchor bolts using a 3/4 inch

ﬂat washer and 2-3/4 inch hex nuts. One 3/4 inch hex nut is supplied with the anchor bolt kit

and the second 3/4 inch hex nut is supplied with the antenna.

NOTE: Ground mount positioning on the foundation is dependent upon predetermined

azimuth viewing requirements. The ground mount assembly arm should be opposite the

satellite requirement. If your site is in the Northern hemisphere, your satellite will be located in

the South. If your site is in the Southern hemisphere, your satellite will be located in the North.

Remove the steel strapping from the ground mount assembly.

Tighten the foundation hardware using the A-325 tensioning procedure.

Figure 18 shows the ground mount assembly attached to the foundation

Installation Procedures

Step 4

Step 5

Step 6

Figure 18