Specifications

Chapter 2 - Installation
42S315F 2-36
CAUTION
Wear only soft-sole shoes or socks while inside the reflector.
Only step on the seams between panels where the structure is
strongest, never in the middle of a panel.
Perform the following procedure to install and align the feed:
1. Choke two nylon straps around the feed assembly and attach to
lifting hook of crane as shown in Figure 2-6.
Figure 2-6. Hoisting Feed
2. With one person inside the hub and one person inside the reflector,
carefully lift the feed up inside the reflector.
3. Orient feed properly (top of feed toward top of reflector) and attach to
polarization drive ring of hub assembly using eight 3/8-16 X 1.75
screws and flat washers.