Specifications

Step 2
29
Installation Procedures
Gently lower the reflector assembly into position and attach to elevation pivot lugs using 3/4”
hardware as shown in Figure 19. Note: Refer to A325 Tensioning Procedure on page 13.
• Use indicated hardware and securely tighten.
Note: After attaching the reflector, the crane may now be removed while the antenna is
in the zenith position.
Figure 19 (Manual Mount)
3/4”
Galvanized
Flat
Washer
(9997-202)
3/4 x 2-1/4”
A325 Bolt and Nut
Assembly (45980-25)
3/4 x 2-1/4”
A325
Bolt and Nut
Assembly
(45980-25)
302677
Pedestal Assembly
Top of Hub
Assembly
Reference Drawing 240299
Figure 19A (Motorized Mount)
302508
Antenna Pack
208366
Az/El Jack Assembly
303158
Pedestal Assembly
Both Sides
45980-31
5/8” x 4” Lg
Bolt/Nut Assembly (2 Places)
9997-227 5/8” Flatwasher
(4 Places)
9997-202
Flatwasher
45980-25
3/4” x 2-1/4” Lg
Bolt/Nut Assembly
Reference Drawing 240349
9997-202
Flatwasher
303882,
Spacer Bar
9997-202
Flatwasher
45980-25
3/4” x 2-1/4” Lg
Bolt/Nut Assembly
9997-202
Flatwasher
303882,
Spacer Bar