User's Manual

ManualsBrandsAndrew ManualsElectronicsMobile Data Radio

Table Of Contents

GENERAL MANUAL INFORMATION
PREPARATION FOR STORAGE OR SHIPMENT
- STORAGE
- SHIPMENT
DESCRIPTION OF EQUIPMENT
- TYPE OF EQUIPMENT
- PURPOSE OF THE EQUIPMENT
LOCATIONS AND DESCRIPTIONS OF MAJOR COMPONENTS
- MOBILE DATA RADIO ASSEMBLY
- BASE STATION RADIO ASSEMBLY
EQUIPMENT CHARACTERISTICS
- POWER AND UTILITY REQUIREMENTS
- ENVIRONMENTAL INFORMATION
INSTALLING THE RADIO EQUIPMENT
- UNPACKING AND INSPECTION
- PROPER INSTALLATION OF UNITS
INTERCONNECTIONS
- MOBILE CONFIGURATION INTERCONNECTION
- WAYSIDE CONFIGURATION INTERCONNECTION
CABLE AND GROUND REQUIREMENTS
- CONNECTOR PIN-OUTS
COMPONENT JACK LOCATIONS
- MOBILE DATA RADIO JACK LOCATIONS
- BASE STATION DATA RADIO JACK LOCATIONS
INITIAL PREPARATION FOR USE
- SETTING UP COMMUNICATIONS WITH THE LCP TERMINAL PORT
- DIAGNOSTIC/LCP TERMINALS
  - RCS MAINTENANCE AND UPGRADE MENU
- VEHICLE LCP MENU
- MDR INITIAL OPERATIONAL ADJUSTMENTS
- WAYSIDE LCP MENU
- BDR INITIAL OPERATIONAL ADJUSTMENTS
  - UNIQUE RCS ADDRESS QUALIFIER
  - THRESHOLD VERIFICATION
RADIO APPLICATION CODE UPGRADE
PN SPREADING CODE SELECTION
ANTENNA AND CABLE INSTALLATION
CONTROLS AND INDICATORS
- MDR CONTROLS AND INDICATORS
- BDR CONTROLS AND INDICATORS
STARTUP AND SHUTDOWN PRODECURES
- MDR STARTUP
- BDR STARTUP
- NORMAL OPERATION
- SHUTDOWN
OUTPUT POWER SETTINGS
ANTENNA PLACEMENT
FUNCTIONAL DESCRIPTION OF EQUIPMENT
- MOBILE DATA RADIO AND BASE DATA RADIO
- RADIO NETWORK ARCHITECTURE
- MDR/BDR COMMUNICATIONS HANDLING
- PN SPREADING CODES
- ANTENNA SWITCHING CONTROLS
PREVENTIVE MAINTENANCE, INSPECTION, AND CLEANING
TROUBLESHOOTING
CORRECTIVE MAINTENANCE
- REMOVE AND REPLACE MDR
- REMOVE AND REPLACE BDR
TEST PROCEDURES
- MDR POWER VERIFICATION
- BDR POWER VERIFICATION
MDR TESTS
- MDR TRANSMITTER TEST SETUP
- MDR TRANSMITTER FAULT ISOLATION TEST
- MDR ONLY RECEIVER FAULT ISOLATION TEST SETUP
- MDR ONLY RECEIVER FAULT ISOLATION TEST
- MDR/BDR RECEIVER TEST SETUP
BDR TESTS
- BDR TRANSMITTER SETUP
- BDR TRANSMITTER FAULT ISOLATION TEST
- BDR ONLY RECEIVER FAULT ISOLATION TEST SETUP
- BDR ONLY RECEIVER FAULT ISOLATION TEST
- BDR/MDR RECEIVER TEST SETUP
RADIO DATA PORT TO USER SUPPLIED EQUIPMENT INTERFACE
- EIA-530 DATA PORT TEST SETUP
- EIA 530 DATA PORT TEST
- RS-232 DATA 2 PORT SETUP
- RS-232 DATA 2 PORT TEST
PARTS LIST
BASE DATA RADIO MECHANICAL OUTLINE
DIAGNOSTIC MENU
MDR DIAGNOSTIC LCP MENU
LCP COMMANDS

385700-1006-006 MECHANICAL INFORMATION

Document use is restricted to that described on cover 7-3

The mechanical outline for the Mobile Data Radio is given in Figure 7-3 Mobile Data Radio

Mechanical Outline.

Figure 7-3 Mobile Data Radio Mechanical Outline