Technical information

OM45P_Rev J Page 21 of 28
Table 4.1: Lubrication Chart
Lube
Pt. #
Components to be Lubricated Frequency
(Months)
1 3
Type of
Service
Lube
Type
#/Qty of
Lube
Points
1*
El Jackscrew housing
X
Pressure
Fitting
LE4622
1
2
El Gear Motor Housing Fill and Drain***
X
(inspect) X
Pipe Plugs**
SHC624 10 ounces
3*
Az Jackscrew Housing
X
Pressure
Fitting
LE4622
2
4
Az Gear Motor Housing Fill and Drain***
X
(inspect) X
Pipe Plugs**
SHC624 10 ounces
5*
Panning frame tube assembly & thrust pads
X
Aerosol Spray Dry Moly
Lubricant
Surface
coverage
X = Lubricate I = Inspect C = Change
* Inspection requires checking for visible signs of leakage. Drain, replace, and add oil to ensure appropriate level
requirements. Excessively dirty oil requires replacement with fresh oil. In case of excessive oil leakage, refer to appropriate
troubleshooting info. Periodic inspections can be less frequent after the second scheduled inspection is completed without
problems.
** Initial oil change requirements include flushing gear boxes with a standard cleaning agent.
*** For motors that have no visible drain or fill plugs no maintenance is required and just a general inspection for oil leakage