User guide

Section 2–Controller Setup ATC200-LITE-USB Teletilt
®
RET System
2-3 October 2014 Bulletin 639536 • Revision L
Figure 2-3. ATC200-LITE-USB Controller End Panels.
RS-232
Serial Port
dc IN Port
USB Port
Data LED flashes green on transmitting and red on receiving signals.
Power LED is green when power is input.
+12 and +24 LEDs are lit to show voltage level output.
AISG female port for
control cable from antenna.
2.3 Controller Setup
Connect the supplied 24 Vdc power converter to the dc IN port on the controller (Figure 2-3).
Verify that the PWR LED turns green.
1. Using a USB Connection
• Connect the supplied USB cable between the controller and the PC. See Figure 2-3 for port
connections on the controller.
The first time you connect a given ATC200-LITE-USB controller to a given local
computer, the drivers will be loaded automatically for the USB connection.
• If you are prompted to locate/install the USB driver for the new device found, then the drivers
failed to install during the installation process.
Proceed as given below.
• Follow the steps shown in Figures 2-4 through 2-6 to successfully install the USB driver for the
ATC200-LITE-USB controller.
• See paragraph 2.4 to launch the ATC Lite program and view the USB port assignment.
Microsoft, Encarta, MSN, and Windows are either registered trademarks or trademarks of Microsoft Corporation in the United States
and/or other countries.