Troubleshooting guide

Bulletin 639519 • Revision D May 2009 15-1
Section 15
Setting IP Addressing on a PC Using Vista to
Connect to ATC200-1000 or ATC300-1000
Microsoft, Encarta, MSN, and Windows are either registered trademarks or trademarks of Microsoft Corporation in the United States and/
or other countries.
15.1 Setting an IP Address Using Windows Vista
™
The following procedure will show you how to change your IP Address if operating a Windows Vista
computer, so you can network with the ATC200/300-1000 controller.
This procedure will only work on controllers that are still set up with the default IP Address
192.168.255.141 and with Subnet Mask 255.255.255.0. If your default address has been changed,
consult your operations manual for procedure to reset the default IP address.
From your desktop, you are going to select 1. Start
 Control Panel (Figure 15-1).
Figure 15-1. Selecting Control Panel.