Troubleshooting guide

Section 13–USB Driver Issues-ATC200-LITE-USB Remote Electrical Downtilt System Handbook

13-4 May 2009 Bulletin 639519 • Revision D

Hardware Installation Click on Continue Anyway.

Files Needed

If this screen appears, …reenter the ﬁ le from previ-

ous step. (Check spelling.) OK

Found New Hardware Wizard:

Completing the Found New Hard-

ware Wizard

Finish

13.2 Correcting USB Driver Problem on Vista

The following steps show you how to correctly install ATC200-Lite-USB drivers on a PC running on

Windows

Vista.

Prior to installing hardware drivers you must ﬁ rst connect your ATC200-Lite-USB to your 1.

computer using the USB cable.

Connect power to your ATC200-Lite-USB.2.

From your Desktop, select 3. Start→Control Panel. The little ﬂ ag in the bottom left hand corner

is your Start button.

Select 4. Device Manager from your Control Panel (Figure 13-1).

Table 13-3. Correcting USB Driver Problems (continued from previous page).

Microsoft, Encarta, MSN, and Windows are either registered trademarks or trademarks of Microsoft Corporation in the United States

and/or other countries.

Figure 13-1. Windows Vista Control Panel

Selecting the

Device Manager

Icon.