Technical information
OM76_Rev J Page 17 of 28
4.0 Preventive Maintenance
These sections contain periodic preventative maintenance instructions for the 7.6m Earth Station Antenna.
Included are instructions for performing inspections, preventative maintenance procedures, and cleaning.
NOTE: Refer to applicable vendor manuals for any repair procedures that are not included in this manual.
These sections describe cleaning, inspections, and preventative maintenance procedures. Regularly replacing
normally functioning assemblies or components as a preventative measure is not required. Malfunctions of this
ESA can normally be traced to components and/or parts through the use of troubleshooting procedures.
4.1 General Cleaning
To prevent excessive accumulation of dust and dirt, as well as to ensure the removal of various contaminants,
the equipment needs to be thoroughly cleaned. It is recommended that you clean the antenna every time you
conduct a visual inspection of the components. No special cleaning procedures are required. However, to
ensure trouble-free operation you will need to clean in accordance with procedures in Sections 4.1.1 & 4.1.2.
4.1.1 Electrical Parts
CAUTION: Confirm ALL ELECTRICAL POWER IS REMOVED BEFORE proceeding.
Minor cleaning, such as the removal of dust and loose foreign particles, can be accomplished by one or all
of the following methods:
Vacuuming
Using a soft-bristle brush or lint-free cloth
Using an air compressor, with dry air at a LOW PRESSURE (between 5 and 25 psi), to blow out dust
and dirt
NOTE: When using air to clear contaminants, take extreme care when blowing air stream on or near ANY delicate parts.
To remove imbedded dirt, grease, and/or oil from electrical parts:
Use a 50% solution of Isopropyl “rubbing” alcohol
Apply to surface with a soft-bristle brush
NOTE: At times, it may be necessary to brush some parts vigorously with a stiff bristle brush in order to remove imbedded
or hardened dirt particles.
NOTE: After cleaning, ALLOW CLEANED PARTS TO DRY FOR 10-15 MINUTES before restoring power and/or
returning equipment to operation.
4.1.2 Mechanical parts
Cleaning of mechanical parts begins by removing dust, dirt, and other loose contaminants with a scraper,
stiff-bristle brush (or wire brush in cases of rust or corrosion removal), lint-free cloth, or compressed air
(pressure between 25 and 40 psi). Any accumulation of imbedded dirt, corrosion, grease, or oil deposits
which require more cleaning may be removed with a stiff-bristle or wire brush, along with a cleaning solvent
such as trichloroethylene (or equivalent).
NOTE: After cleaning, ALLOW CLEANED PARTS TO DRY FOR 10-15 MINUTES before restoring power and/or
returning equipment to operation.
4.2 Inspections
The frequency of inspection is contingent upon the user’s individual standards and the operational environment
in which the earth station antenna is located. However, a visual inspection of the components should be
performed at least semi-annually. Where there are no established wear limits, perform a visual inspection to
locate worn or damaged parts that could result in a malfunction of the earth station antenna. It is recommended
that the mechanical and electrical inspections be performed on the assembled or partially disassembled
equipment to determine the extent of disassembly required prior to completely disassembling a component or
module that is suspected of malfunctioning.
In the absence of any special inspection requirements, operational tests are the most effective means in
isolating parts and assemblies requiring further inspection. During inspection, any noted damage and/or
problematic condition which could preclude the continuation of proper operation (prior to the next scheduled
inspection) should be recorded. These discrepancies should be immediately corrected (either by repair or
replacement, as required), or dealt with immediately after the inspection procedure has been completed.