Technical information

OM56_Rev G Page 7 of 28
I.VII Things to Never Do
 NEVER touch circuits or reach into an enclosure until the disconnection of power and absence of charge has
been confirmed
 NEVER service or adjust equipment alone. Electric shock can lead to cardiac arrest. Presence of immediate
aid gives you a 90% chance of survival, but this drops by 10% with every passing minute. After 5
minutes resuscitation without permanent heart and/or brain damage is nearly impossible. Consider
this: Without the immediate aid of CPR or an AED, what are the odds you will be found and
successfully revived in less than 5 minutes?
 NEVER ignore warning symbols or fail to read safety signs
 NEVER skip steps in a sequence, unless specifically instructed to do so by the manual, software, and/or
authorized ASC Signal Tech Support Personnel. Aside from risking harm to yourself, you risk doing
permanent damage to the equipment
 NEVER touch or stand near any potentially moving parts (even if they are not in motion at the time) when the
unit is in operation or powered on, as they may move without warning
 NEVER stand underneath any object while it is being lifted
 NEVER stand in front of, inside of, or near the antenna or feed while the antenna is in operation, as severe
eye damage and/or bodily injury may result from exposure to Radio Frequency (RF) radiation.
 NEVER begin any task without first donning the proper safety equipment for the situation (hardhats, gloves,
goggles, etc.)
 NEVER remove, disable, or exceed the unit’s safety, software, security, or movement limits, unless
specifically instructed to do so by the manual, software, and/or authorized ASC Tech Support Personnel. The
careless disabling of such safeguards is one of the most common causes of serious equipment damage
during installation and operation
I.VIII Parts Verification
STOP! READ BEFORE BEGINNING ASSEMBLY OR INSTALLATION!
Upon receipt of your order, the shipment should be verified to ensure that all parts have reached your site. This
process should occur before the installation process begins. ASC Signal Corporation thoroughly inspects and
carefully packs all equipment before shipment. If you find that there are missing or damaged components,
please refer to the step-by-step instructions (located in back of this manual) on how to properly report
equipment loss or damage. When you have received your order, verify that all parts contained in the shipment
correspond to the parts listed on your packing slip/inventory.