User's Manual

4. Commissioning
7.Manual MF0200A0A ION-U_H_17P2_uc_19-July-13.docx User’s
Manual for ION
®
U
Page 35
Align and assemble LC support with split gasket or and clamp .
Insert this assembly into the plug body as shown. The inside pin of the
clamp must be aligned with the groove in the split gasket.
figure 4-23 Assemble Opus short plug
figure 4-24 Insert LC connector plug into plug body
Screw the adapter nut onto the body (2 N.m maximum torque).
figure 4-25 Tighten Opus short plug adapter nut
4.2.11.2. Connect Opus short plug to RU
Pull on the plug’s collar to remove the protection cap.
figure 4-26 Remove Opus short plug protective cap
5
3
4
2
6
1
4
Inside Pin
Flat surface
Slot alignment mark
5
1
Protective cap