User's Manual

4. Commissioning
Page 34
7.Manual MF0200A0A ION-U_H_17P2_uc_19-July-13.docx
User
’
s Manual for ION
®
U
Simplex Cable Duplex Cable
Place the simplex split gasket on
the cable using the split on the side of
the gasket with the larger diameter of
the gasket toward the front.
Place the duplex split gasket on the
cables using the split on both sides of
the gasket with the larger diameter of the
gasket toward the front. Ensure that the
channel positioning is correct as shown.
figure 4-19 Simplex split gasket figure 4-20 Duplex split gasket
Insert the LC connector by its side
into Cavity A of LC support until it
clicks into place.
Insert the LC connectors by their sides
into the LC support until they click
into place. Ensure that the channel
positioning is correct as shown.
figure 4-21 Simplex Cavity A figure 4-22 Duplex Cavity A & B
 Note: The LC latch must be pressed down in order to slide it into the
cavity of the LC support.
 Note: Remove the LC protection cap after completing step 3 (or 3b).
3
4
5
5
2 2b
3 3b
click
click
Channel BChannel A
click
Channel A
Free slot
Flat surface
Channel B
Channel A
Flat surface