User's Manual

4. Commissioning
7.Manual MF0200A0A ION-U_EU H 19P2_uc_08-July-13.docx
User
’
s Manual for ION
®
U
Page 19
4.1.3. Pole Mounting Procedure
Standard mounting hardware cannot be used to mount the remote unit to a pole, a
column, or other similar structures. Additional hardware must be used for this type of
installation. The pole-mounting kit includes two mounting brackets with screw band
(worm gear) clamps to mount the brackets to the pole and two nuts, flat washers, and
lock washers per bracket to attach the remote unit to the bracket.
figure 4-2 Pole mounting kit
 Use the screw bands to fasten the two brackets to the pole as illustrated in figure
4-3 Pole mounting drawing.
 Place the bands around the pole or post and feed the loose end into the lock as
shown and tighten the slotted screw securely. When the screw is turned
clockwise, it acts as a worm drive pulling the threads of the band causing the
band to tighten around the pole.
 Note: When fastening the brackets make sure that they are installed
congruently and not at an angle to each other. To determine the
distance between the clamps refer to figure 4-1 Wall Mounting for
measurements.
Flat washer
Lock washer
Nut
Mounting bracket 1 with screw clamp
Mounting bracket 2 with screw clamp
Lock for screw band
Slotted screw to
tighten clamp