User's Manual

4. Commissioning

Page 18

7.Manual MF0200A0A ION-U_EU H 19P2_uc_08-July-13.docx

User

’

s Manual for ION

4.1.2. Wall-Mounting Procedure

 Check the suitability of the wall-mounting kit and the wall.

1. Mark the position of the drilling

holes (for measurements refer to

(figure 4-1 Wall Mounting). Drill

four holes at the marked positions

and insert dowels*.

 Use a cap nut or lock nut to screw

the four dowel screws into the

dowels and put the distance tubes

over the screws.

 Hang the mounting brackets of the

remote unit into the screws, and

fasten them immediately using the

washers and nuts.

 Ensure that there is free access to

the electrical connections as well

as to the cabinet. The approved

bending radius of the connected

cables must not be exceeded.

figure 4-1 Wall Mounting

* The dowels are not included with the delivery because the suitable type depends on the on-site

conditions (material of wall). Use dowels or other fasteners that are the most appropriate for the

mounting surface.

It is the responsibility of the installer to verify that the supporting surface will

safely support the combined load of the electronic equipment and all attached

hardware and components and to ensure that the RU/EU is safely and securely

mounted.