User's Manual

4. Commissioning
MF0200A5C_ION-U_L_7_80-85_17EP_19P.docx Manual for ION
®
-U Page 27
3. Fasten the lower section of the unit to the bracket using a washer and an
M6x12 screw (on both sides). Slide a washer over each screw and then insert
the screw and tighten it securely.
figure 4-7 Install M6x12 screws and washers for single mount
4. Fasten the unit to the bracket using a washer and M6 nut. Slide the washer
over the threaded pins that you installed previously (chapter 4.1.3) and then
screw the nut onto the pins (on both sides) and tighten securely.
figure 4-8 Attach M6 nut to threaded pins for single mount
5. Confirm that all screws and nuts have been fastened and the unit is securely
mounted to the wall.
M6x12 screw
Washer
M6 nut
Washer