User's Manual

User’s Manual for ION-B Systems

Page 19

3. Fasten the lower section of the Remote Unit to the bracket using a washer

and an M6x12 screw (on both sides). Slide a washer over each screw and

then insert the screw and tighten it securely.

B0400AL

M6x12 screw

Washer

Figure 2-7 Install M6x12 screws and washers for single mount

4. Fasten the Remote Unit to the bracket using a washer and M6 nut. Slide the

washer over the threaded pins that you installed previously (chapter 0) and

then screw the nut onto the pins (on both sides) and tighten securely.

B0400AMA

M6 nut

Washer

Figure 2-8 Attach M6 nut to threaded pins for single mount

5. Confirm that all screws and nuts have been fastened and the unit is securely

mounted to the wall.