User's Manual

User’s Manual for ION-B Systems

Page 15

2.1.3. TFAx Case U Mechanical Installation

Each Case U Remote Unit kit includes:

1. a RU TFAx

2. a power supply plug

1. Warning: Do not install the unit in a way or at a place where the

specifications outlined in the Environmental and Safety Specifications

leaflet of the supplier are not met.

2. WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT

FALLING CAUSING SERIOUS PERSONAL INJURY OR DAMAGE TO

EQUIPMENT. The installer must verify that the supporting surface will safely

support the combined load of the electronic equipment and all attached

hardware and components. The screws and dowels (wall anchors) used

should also be appropriate for the structure of the supporting wall.

3. Warning: It is recommended to use the mounting hardware delivered by the

manufacturer only. If different mounting hardware is used, the

specifications for stationary use of the Remote Unit must not be exceeded.

 Note: Exceeding the specified load limits may cause the loss of

warranty!

5. Warning: The unit is considerably heavy. Ensure there is adequate

manpower to handle the weight of the system.

6. Caution: Due to power dissipation, the Remote Unit may reach a very high

temperature. Ensure sufficient airflow for ventilation.

7. Note: When connecting and mounting the cables (RF, optical, mains, ...)

ensure that no water can penetrate into the unit through these cables.

8. Note: Observe all additional rules or restrictions regarding mounting that

apply to specific Remote Unit types.

If any different or additional mounting material is used, ensure that the mounting

remains as safe as the mounting designed by the manufacturer. Ensure that the

static and dynamic strengths are adequate for the environmental conditions of the

site. The mounting itself must not vibrate, swing or move in any way that might cause

damage to the Remote Unit.

Specified torques must be observed for certain mounting procedures according to the

following table:

Type Pins Hex nuts Screws

Thread

M 6 M 6 M6

Specified torques

3.3 Nm 3.3 Nm 3.3 Nm

Table 2 Specified torques