User's Manual

User’s Manual for ION-B Systems
Page 21
3. Fasten the lower section of the Remote Unit to the bracket using a washer
and an M6x12 screw (on both sides). Slide a washer over each screw and
then insert the screw and tighten it securely.
Install M6x12 screws and washers for single mount
4. Fasten the Remote Unit to the bracket using a washer and M6 nut. Slide the
was
her over the threaded pins that you installed previously and then screw
the nut onto the pins (on both sides) and tighten securely.
Attach M6 nut to threaded pins for single mount