User Manual

1. General
Page 9
4. Notice: For installations which have to comply with FCC/ISED requirements:
English:
This device complies with FCC Part 15. Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
This device complies with Health Canada’s Safety Code 6. The installer of this device
should ensure that RF radiation is not emitted in excess of the Health Canada’s
requirement. Information can be obtained at http://www.hc-sc.gc.ca/ewh-
semt/pubs/radiation/radio_guide-lignes_direct-eng.php.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Antenna Stmt for ISED:
This device has been designated to operate with the antennas having a maximum gain of
9 dBi. Antennas having a gain greater than 9 dBi are prohibited for use with this device
without consent by ISED regulators. The required antenna impedance is 50 ohms.
The antenna(s) used for this transmitter must be installed to provide a minimum separation
distance (as specified in table 1-1) from all persons and must not be co-located or
operating in conjunction with any other antenna or transmitter. Users and installers must
be provided with antenna installation instructions and transmitter operating conditions for
satisfying RF exposure compliance.
French:
Cet appareil est conforme avec Santé Canada Code de sécurité 6. Le programme
d’installation de cet appareil doit s’assurer que les rayonnements RF n’est pas émis au-
delà de I’exigence de Santé Canada. Les informations peuvent être obtenues:
http://www.hc-sc.gc.ca/ewh-semt/pubs/radiation/radio_guide-lignes_direct-fra.php
Antenne Stmt pour ISDE:
Ce dispositif a été désigné pour fonctionner avec les antennes ayant un gain maximal de
9 dBi. Antennes ayant un gain plus grand que 9 dBi sont interdites pour une utilisation
avec cet appareil sans le consentement des organismes de réglementation d’ISDE.
L’impédance d’antenne requise est 50 ohms.
L’antenne (s) utili pour cet émetteur doit être installé pour fournir une distance de
séparation minimale (comme indiqué dans le table 1-1) par rapport à toute personnes et
ne doit pas être co-localisées ou opérant en conjonction avec une autre antenne ou
émetteur. Les utilisateurs et les installateurs doivent être fournis avec des instructions
d’installation de l’antenne et des conditions de fonctionnement de l’émetteur pour
satisfaire la conformité aux expositions RF.