User Manual

4. Commissioning
MF0123A1A PSR 700/800 MHz
Page 17
5. Notice: Do not place cables or tools that may damage the repeater in close
proximity to it.
6. Notice: Do not wear jewelry or metal accessories when installing this repeater.
7. Notice: When connecting and mounting the cables (RF, optical, mains, ...) ensure
that no water can penetrate into the unit through these cables.
8. Notice: Check all cables for shorts and opens. Verify that there are no cables
with loose or poor connections. RF leakage could cause oscillation to occur
under some conditions.
9. Notice: If any different or additional mounting material is used, ensure that the
mounting remains as safe as the mounting designed by the manufacturer. The
specifications for stationary use of the Unit must not be exceeded. Ensure that the
static and dynamic strengths are adequate for the environmental conditions of the
site. The mounting itself must not vibrate, swing or move in any way that might
cause damage to the Unit.
10. Notice: A spacing of 40 mm (1.58 inch) around the unit is required.
Specified torques must be observed for certain mounting procedures according to the
following table:
Type
Pins
Hex nuts
Screws
Thread
M 6
M 6
M6
Specified torques
3.3 Nm
3.3 Nm
3.3 Nm
table 4-1 Specified torques
4.1.3. Mounting Procedure
Use the enclosed screws and screw anchors to mount the unit to a wall through the
holes of the four mounting brackets at the unit (two at the top, two at the bottom):