User's Manual
1. General
MF0123A1F_FCC_uc Manual for PSR 700/800 MHz
Page 9
5. Notice: For installations which have to comply with FCC requirements:
This device complies with FCC Part 15. Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
This device complies with Health Canada’s Safety Code. The installer of this device should
ensure that RF radiation is not emitted in excess of the Health Canada’s requirement.
Information can be obtained at http://www.hc-sc.gc.ca/ewh-
semt/pubs/radiation/radio_guide-lignes_direct-eng.php.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
6. Notice: The unit complies with Overvoltage Category II. It also complies with the
surge requirement according to EN 61000-4-5 (fine protection); however, installation
of an additional medium (via local supply connection) and/or coarse protection
(external surge protection) is recommended depending on the individual application
in order to avoid damage caused by overcurrent.
For Canada and US, components used to reduce the Overvoltage Category shall
comply with the requirements of IEC 61643-series. As an alternative, components
used to reduce the Overvoltage Category may comply with ANSI/IEEE C62.11, CSA
Certification Notice No. 516, CSA C22.2 No. 1, or UL 1449. Suitability of the
component for the application shall be determined for the intended installation.
7. Notice: Corresponding local particularities and regulations (in particular, National
Electrical Code NFPA 70, Fire Code NFPA 1, Life Safety Code NFPA 101,
International Fire Code) must be observed.
8. Note: For a Class A digital device or peripheral:
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his
own expense.
9. Note: Class B broadband operations that include the ESMR frequency bands 817-
824 MHz and 862-869 MHz are permitted only when installed indoors due to section
90.219(d)(7) of the FCC rules which says: “Except for distributed antenna systems
(DAS) installed in buildings, the passband of a [Part 90] Class B booster should not
encompass both commercial services (such as ESMR and Cellular Radiotelephone)
and part 90 Land Mobile and Public Safety Services.”
10. Note: Follow the Good Engineering Practices and be a Good RF Neighbor:
Good engineering practice must be used in regard to the signal booster’s noise
radiation. Accordingly, the gain of the signal booster should be set so that the ERP
of the output noise from the signal booster should not exceed the level of -43 dBm
in 10 kHz measurement bandwidth. In the event that the noise level measured
exceeds that value, the signal booster gain should be decreased accordingly. Also,
please note that in general, the ERP of noise on a spectrum more than 1 MHz outside
of the pass band should not exceed -70 dBm in a 10 kHz measurement bandwidth.