User's Manual

4. Commissioning
Page 20
MF0123A1F_FCC_uc Manual for PSR 700/800 MHz
⚫ At the four positions marked with the bracket as the template, drill four holes into
the wall using a drill bit that matches the thickness of the M6 wall anchors (not part
of the delivery; see Notice under table 4-2). Then, insert each of the four wall
anchors into the holes:
⚫ Gently tap the wall anchors with a hammer to fully insert them into the wall.
⚫ While holding the bracket in place, insert the four M6 x 40 mm tapping screws into
the wall anchors and tighten them to fasten the bracket to the wall.
⚫ Confirm that the bracket is securely fastened before moving to the next step.
When the bracket is securely fastened to the wall, insert the PSR into the bracket by
positioning the two bolts (one at each side) in the corresponding grooves of the bracket.
Also, reinstall the positioning clips in case they fell off before: