User's Manual
Table Of Contents
- 1. GENERAL
- 2. INTRODUCTION
- 3. CONNECTION SETUP
- 4. INSTALLATION
- 5. FUNCTIONAL DESCRIPTION
- 5.1. DIGITAL ARCHITECTURE
- 5.2. FEATURES
- 5.2.1. Filters Node M
- 5.2.2. Filters Node C
- 5.2.3. Digital ICE (Digital Interference Cancellation Equipment)
- 5.2.4. VSWR (Voltage Standing Wave Ratio)
- 5.2.5. RSSI (Receive Signal Strength Indication)
- 5.2.6. Alarm Forwarding
- 5.2.7. Downlink Final Amplifier
- 5.2.8. Power Supply Unit
- 5.2.9. Modems
- 5.2.10. Digital Channel Module (DCM)
- 5.2.11. External Alarm Controller - EAC-Board
- 5.2.12. Battery Pack - Battery On/Off
- 5.2.13. UL and DL Duplexer
- 6. MAINTENANCE AND REPLACEMENT
- 7. ILLUSTRATIONS
- 8. INDEX
User’s Manual for Node M and Node C
Network Elements
Page 56 M0121A4A.doc
Battery On/Off
A pushbutton on the EAC-board is implemented to disconnect the battery pack from
the controller. This forces a hard reset of the system.
Once disconnected, the power to the controller will not be restored until the +28V
supply is again operational.
Battery
disconnect
button
figure 5-27 Position of the battery disconnect button
on the EAC-board