User's Manual
Table Of Contents
- 1. GENERAL
- 2. INTRODUCTION
- 3. CONNECTION SETUP
- 4. INSTALLATION
- 5. FUNCTIONAL DESCRIPTION
- 5.1. DIGITAL ARCHITECTURE
- 5.2. FEATURES
- 5.2.1. Filters Node M
- 5.2.2. Filters Node C
- 5.2.3. Digital ICE (Digital Interference Cancellation Equipment)
- 5.2.4. VSWR (Voltage Standing Wave Ratio)
- 5.2.5. RSSI (Receive Signal Strength Indication)
- 5.2.6. Alarm Forwarding
- 5.2.7. Downlink Final Amplifier
- 5.2.8. Power Supply Unit
- 5.2.9. Modems
- 5.2.10. Digital Channel Module (DCM)
- 5.2.11. External Alarm Controller - EAC-Board
- 5.2.12. Battery Pack - Battery On/Off
- 5.2.13. UL and DL Duplexer
- 6. MAINTENANCE AND REPLACEMENT
- 7. ILLUSTRATIONS
- 8. INDEX
5 Functional Description
Page 39
5.2. FEATURES
5.2.1. Filters Node M
Filters are set automatically according to the channels set in “Setup Wizard” or
“Technician Setup”. For further information about these menus refer to the user's
manual for Node software.
UMTS - Possible filters are:
5 5 MHz
One
UMTS
channel
One
UMTS
channel
5.2.2. Filters Node C
Filters are set automatically according to the channels set in “Setup Wizard” or
“Technician Setup”. For further information about these menus refer to the user's
manual for Node software.
CDMA - Possible filters are:
1.23 16 x 1.23 MHz
one CDMA
channel
sixteen adjacent
CDMA channels