User's Manual
Table Of Contents
- 1. GENERAL
- 2. INTRODUCTION
- 3. CONNECTION SETUP
- 4. INSTALLATION
- 5. FUNCTIONAL DESCRIPTION
- 5.1. DIGITAL ARCHITECTURE
- 5.2. FEATURES
- 5.2.1. Filters Node M
- 5.2.2. Filters Node C
- 5.2.3. Digital ICE (Digital Interference Cancellation Equipment)
- 5.2.4. VSWR (Voltage Standing Wave Ratio)
- 5.2.5. RSSI (Receive Signal Strength Indication)
- 5.2.6. Alarm Forwarding
- 5.2.7. Downlink Final Amplifier
- 5.2.8. Power Supply Unit
- 5.2.9. Modems
- 5.2.10. Digital Channel Module (DCM)
- 5.2.11. External Alarm Controller - EAC-Board
- 5.2.12. Battery Pack - Battery On/Off
- 5.2.13. UL and DL Duplexer
- 6. MAINTENANCE AND REPLACEMENT
- 7. ILLUSTRATIONS
- 8. INDEX
User’s Manual for Node M and Node C
Network Elements
Page 26 M0121A4A.doc
4.1.3. Pole Mounting Procedure
The following figure illustrates the pole mounting option back-to-back.
V14
98
A
0
figure 4-3 Pole mounted units
Before starting the mounting procedure, check the pole diameter of the pole to which
the units will be installed.
Then, cut the thread-bolts (see table 4-2 Components of pole mounting kit, pos. 5) to
the required length according to the following table:
Pole-diameter (mm) 100 110 120 130 140 150 160 170 180 190 200
Length of thread-bolt (mm) 216 226 236 246 256 266 276 286 296 306 316
table 4-1 Required length of thread-bolts