User's Manual
Table Of Contents
- 1. GENERAL
- 2. INTRODUCTION
- 3. CONNECTION SETUP
- 4. INSTALLATION
- 5. FUNCTIONAL DESCRIPTION
- 5.1. DIGITAL ARCHITECTURE
- 5.2. FEATURES
- 5.2.1. Filters Node M
- 5.2.2. Filters Node C
- 5.2.3. Digital ICE (Digital Interference Cancellation Equipment)
- 5.2.4. VSWR (Voltage Standing Wave Ratio)
- 5.2.5. RSSI (Receive Signal Strength Indication)
- 5.2.6. Alarm Forwarding
- 5.2.7. Downlink Final Amplifier
- 5.2.8. Power Supply Unit
- 5.2.9. Modems
- 5.2.10. Digital Channel Module (DCM)
- 5.2.11. External Alarm Controller - EAC-Board
- 5.2.12. Battery Pack - Battery On/Off
- 5.2.13. UL and DL Duplexer
- 6. MAINTENANCE AND REPLACEMENT
- 7. ILLUSTRATIONS
- 8. INDEX
User’s Manual for Node M and Node C
Network Elements
Page 2 M0121A4A.doc
© Copyright 2010 CommScope, Inc.
All rights reserved.
Andrew Solutions is a trademark of CommScope, Inc.
All information contained in this manual has been revised thoroughly. Yet Andrew
Solutions accepts no liability for any omissions or faults.
Andrew Solutions reserves the right to change all hard- and software characteristics
without notice.
Names of products mentioned herein are used for identification purposes only and
may be trademarks and / or registered trademarks of their respective companies.
No parts of this publication may be reproduced, stored in a retrieval system,
transmitted in any form or by any means, electronical, mechanical photocopying,
recording or otherwise, without prior written permission of the publisher.
Andrew Wireless Systems GmbH, 05-February -2010