User's Manual
Table Of Contents
- 1. GENERAL
- 2. INTRODUCTION
- 3. COMMISSIONING
- 3.1. MECHANICAL INSTALLATION
- 3.2. ELECTRICAL INSTALLATION
- 3.3. CONNECTION OF THE ANTENNA CABLES
- 3.4. POWER CONNECTION
- 3.5. OPTICAL-FIBER-CABLE CONNECTION - RULES
- 3.6. COMMISSIONING
- 3.7. BITE AND ALARMS
- 3.8. HANDLING OF ALARMS
- 3.9. ALARM STATUS
- 3.10. STATUS LED ALARMS
- 3.11. EXTERNAL ALARM INPUTS AND OUTPUTS
- 3.12. TROUBLESHOOTING
- 4. MAINTENANCE
- 5. APPENDIX
- 6. INDEX
- LIST OF CHANGES
Page 5
FIGURES AND TABLES
figure 3-1 Mounting bracket installation.................................................................... 17
figure 3-2 RU mounting ............................................................................................ 17
figure 3-3 Pole-mounting kit...................................................................................... 18
figure 3-4 Connector flange of ION-M7P/85P/17P/19P ............................................ 20
figure 3-5 RS485 connector...................................................................................... 21
figure 3-6 Grounding bolt.......................................................................................... 21
figure 3-7 Grounding bolt, schematic view................................................................ 21
figure 3-8 AC power supply plug............................................................................... 23
figure 3-9 Protective-plug assembly ......................................................................... 26
figure 3-10 Tube-kit installation................................................................................. 29
figure 4-1 Flange connector, 5 poles ........................................................................ 35
figure 4-2 Flange connector, 7 poles ........................................................................ 35
figure 4-3 Alarm inputs and outputs, standard.......................................................... 36
figure 5-1 Fan unit and heat sink .............................................................................. 38
figure 6-1 Cabinet drawing........................................................................................ 40
table 1-1 List of international contact addresses....................................................... 12
table 3-1 Specified torques....................................................................................... 16
table 3-2 RS485 connector, pin assignment............................................................. 21
table 4-1 Status LED alarms..................................................................................... 34